This series product is a 2 cavity type counterattack crusher, with large crushing cavity structure, with high yield, crushing ratio, low energy consumption per unit, high utilization rate of wear parts and easy maintenance etc, especially suitable for less than 320 mpa compressive strength of all kinds of material of broken, such as pebbles, basalt, granite, quartz, etc.,  It is the ideal equipment for high-grade highway, railway, water and electricity, chemical industry, building refractory materials, ceramics, glass and other industries.  

1, special super-large cavity design, greatly improve the crushing rate and productivity;  

2. Compared with the same type of equipment in the same industry, our company can increase by 10-25% against bankruptcy;  

3, the rotor disc vulnerable parts with wear-resistant plate, easy to replace and maintenance;  

4, non-circular rotor structure design, give full play to the plate hammer throwing function, greatly improve the crushing efficiency, reduce the wear of the plate hammer, under the same conditions, the service life of the plate hammer is extended about 20%.  

5, the use of hydraulic open cover structure, hydraulic adjustment counter frame, maintenance and replacement of accessories is simple and convenient;  

6. Simple operation and convenient maintenance.    

The impact crusher uses the hammer on the rotor rotating at a high speed to produce high-speed impact on the material fed into the crushing chamber and crush it, and the crushed material is thrown at a high speed along the tangential direction to the impact plate at the other end of the crushing chamber It was broken, and then rebounded from the counterattack board to the hammer, and continued to repeat the above process. During the round trip, the materials also collide with each other. Because the material is hit by the hammer, the impact with the counterattack and the collision between the materials, the material continues to crack, loose and crushed. When the granularity of the material is smaller than the gap between the impact plate and the hammer, it is discharged.

Note: Technical parameters are subject to change without notice.